The defrost timer is usually located behind the lower kickplate, in the control panel, or on the back wall of your Frigidaire freezer. To replace it, you need to disconnect the power, remove the old timer, and install the new one. You may need a screwdriver, a nut driver, and a new defrost timer for this repair.
How To Locate The Defrost Timer On A Frigidaire Freezer?
The location of the defrost timer may vary depending on your Frigidaire freezer model. You can check your owner’s manual or look up a parts diagram online to find out where it is. Here are some common places where you may find the defrost timer:
- Behind the lower kickplate: The lower kickplate is the panel at the bottom front of your freezer. To access the defrost timer behind it, you need to remove the screws that hold it in place and pull it off. You should see the defrost timer mounted on a metal bracket near the compressor.
- In the control panel: The control panel is the panel at the top front of your freezer where you adjust the temperature settings. To access the defrost timer inside it, you need to remove the screws that hold it in place and pull it down. You should see the defrost timer attached to a wiring harness near the thermostat.
- On the back wall: The back wall is the wall behind your freezer where you plug in the power cord. To access the defrost timer on it, you need to pull out your freezer from the wall and unplug it. You should see the defrost timer mounted on a metal plate near the power cord.
How To Replace The Defrost Timer On A Frigidaire Freezer?
Once you have located the defrost timer on your Frigidaire freezer, you can follow these steps to replace it:
- Disconnect the power: Before you start any repair, you need to disconnect your freezer from the power source for safety reasons. You can do this by unplugging it from the wall outlet or turning off the circuit breaker that controls it.
- Remove the old timer: Depending on where your defrost timer is located, you may need to remove some screws or clips to release it from its mounting bracket or wiring harness. You may also need to use a screwdriver or a nut driver to do this. Once you have removed any fasteners, you can pull out the old timer and disconnect any wires attached to it. Make sure to note how they are connected for later reference.
- Install the new timer: To install the new timer, you need to connect it to the same wires as the old one. You can use wire nuts or electrical tape to secure them. Then, you need to position it in its mounting bracket or wiring harness and secure it with any screws or clips that you removed earlier. Make sure that it is aligned properly and not loose.
- Restore power and test: After you have installed the new timer, you can restore power to your freezer by plugging it back in or turning on the circuit breaker. You can then test if it is working properly by observing if your freezer goes into defrost mode every few hours and if there is no frost buildup on your evaporator coils.
FAQs About The Defrost Timer On A Frigidaire Freezer
Here are some of the frequently asked questions about the defrost timer on a Frigidaire freezer and their answers:
- How do I know if my defrost timer is bad? Some signs that your defrost timer is bad include: – Your freezer is not cooling properly or is too warm – Your freezer is running constantly or not at all – Your freezer has excessive frost or ice buildup on its walls or coils – Your freezer makes loud noises or clicks during its operation
- How do I test my defrost timer? To test your defrost timer, you can use a multimeter or an ohmmeter to measure its resistance or continuity. You can also manually advance it with a screwdriver or a coin and see if it switches between cooling and defrost modes.
- How much does a defrost timer cost? The cost of a defrost timer may vary depending on your Frigidaire freezer model and where you buy it from. You can expect to pay between $10 and $50 for a new defrost timer.
Conclusion
The defrost timer is an important component of your Frigidaire freezer that regulates the defrost cycle and prevents frost buildup. If it fails, it can cause your freezer to malfunction and spoil your food. To fix this, you need to locate and replace the defrost timer on your Frigidaire freezer. By following the steps and tips we’ve shared in this post, you can do this repair yourself and save some money and time.
