How To Put Water Filter In LG Fridge

If you have an LG fridge with a water dispenser and ice maker, you need to put a water filter in it to ensure that you get clean and fresh water. The water filter helps remove impurities and contaminants from the tap water that reaches your fridge. In this blog post, we will show you how to put water filter in LG fridge, as well as how to change and reset it.

To put water filter in LG fridge, you need to locate the water filter housing behind the left side refrigerator door, remove the old water filter by pressing the push button and pulling it down, and install the new water filter by removing the protective cover, pushing it into the manifold hole, and rotating it up.

You may also need to tilt up and pull out the top shelf to access the filter compartment.

How to Put Water Filter in LG Fridge

Before you start putting water filter in LG fridge, you should turn off the water valve that connects to the refrigerator water line. You can find it behind the fridge or under the sink. You should also dispense any remaining water left in the water line through the dispenser or ice maker.

To put water filter in LG fridge, follow these steps:

• Open the refrigerator’s left door and locate the water filter housing at the top left corner inside the refrigerator. You may need to tilt up and pull out the top shelf to access it.
• Press the push button on the filter compartment and pull it down to lower the door of the compartment. You will see the old water filter inside.
• Pull out the old water filter by grasping it firmly and pulling it down. Be careful not to spill any water that might be inside the filter.
• Take your new LG fridge water filter out of its packaging and remove the protective cover from the inlet and outlet ports.
• Push the new water filter into the manifold hole until it clicks into place. Then, rotate it up until it is horizontal.
• Close the filter compartment door by pushing it up until it snaps into place.
• Turn on the water valve that connects to the refrigerator water line and flush about 2 gallons of water through the dispenser or ice maker to remove any air bubbles and activate the filter.

How to Change Water Filter in LG Fridge

LG recommends changing the water filter every 6 months, or sooner if you use the dispenser heavily or your local water supply is dirty. The indicator on the control panel will light up to remind you when it is time to replace the filter.

To change water filter in LG fridge, you can follow the same steps as above for putting water filter in LG fridge. Just make sure that you use a new LG brand filter that is not expired and matches your fridge model. You can find out which filter to use by visiting our Water Filter Finder page or checking your fridge’s manual.

How to Reset Water Filter in LG Fridge

After you put or change water filter in LG fridge, you need to reset the indicator light on the control panel so that it can track when you need to replace the filter again. To reset water filter in LG fridge, follow these steps:

• Locate the reset button on your control panel. It could be labeled as “Filter Reset” or “Water Filter”.
• Press and hold the reset button for 3 seconds until you hear a beep sound or see a green light flashing.
• Check if the indicator light has turned off or changed color.

Conclusion

We hope this blog post has helped you learn how to put water filter in LG fridge, as well as how to change and reset it. If you have any questions or comments, please feel free to leave them below. And don’t forget to check out our other blog posts on kitchen appliances and food safety at PressToCook.com!