If you have a Whirlpool French door refrigerator, you may want to remove the freezer drawer from time to time for cleaning, organizing, or replacing. Removing the freezer drawer from a Whirlpool French door refrigerator is not a hard task, but it does require some care and attention. In this blog post, we’ll show you how to remove the freezer drawer from a Whirlpool French door refrigerator in a few simple steps.
To remove the freezer drawer from a Whirlpool French door refrigerator, you need to open the freezer drawer, lift the basket out, remove the screws and brackets, slide the drawer out, and disconnect the wire harness. To replace the drawer, you need to reverse the steps.
Removing the freezer drawer from a Whirlpool French door refrigerator is not a complicated task, but you’ll need to follow some instructions and precautions. The following steps will guide you through the process of removing the freezer drawer and preparing it for cleaning or replacement.
The first thing you need to do before removing the freezer drawer is to open it until it stops. You may need to pull it firmly to overcome the resistance of the door seal. Make sure you have enough space and light to work on your freezer.
The next thing you need to do is to lift the basket out of the drawer. The basket is the wire or plastic container that holds your frozen food items. It rests on a metal frame that supports it.
To lift the basket out, grasp both sides of the basket and lift it up at the front. Then, pull it forward until it clears the frame and lift it out of the drawer. Be careful not to drop or damage the basket or any items in it.
The next thing you need to do is to remove the screws and brackets that hold the drawer in place. Depending on your model of Whirlpool French door refrigerator, these may be located on the sides or on the back of the drawer.
To remove them, you’ll need a Phillips screwdriver and a flathead screwdriver. Use the Phillips screwdriver to loosen and remove the screws that secure the brackets. Then, use the flathead screwdriver to pry off the brackets from their slots. Keep track of the screws and brackets for later use.
Once you have removed the screws and brackets, you can slide the drawer out of your Whirlpool French door refrigerator. To do this, grasp both sides of the drawer and pull it toward you until it stops. Then, lift up slightly on the front of the drawer and pull it out completely.
Be careful not to damage or scratch your floor or your refrigerator when sliding out your drawer. You may want to place some towels or cardboard under your drawer to protect your floor.
The last thing you need to do before removing your freezer drawer is to disconnect the wire harness that connects your drawer to your refrigerator. The wire harness is a bundle of wires that provides power and communication between your drawer and your refrigerator.
To disconnect it, locate the wire harness connector at the back of your drawer. It may be covered by a plastic cap or tape. Remove any coverings and gently pull apart the connector halves. Be careful not to damage or cut any wires.
To replace your freezer drawer in your Whirlpool French door refrigerator, you need to reverse the steps above. Start by reconnecting the wire harness connector at the back of your drawer. Then, align your drawer with its rails and slide it back into place. Make sure that it is securely attached and slides smoothly.
Next, reattach the screws and brackets that hold your drawer in place. Use your Phillips screwdriver to tighten them securely. Then, lower your basket into your drawer and make sure that it rests on its frame.
Finally, close your freezer drawer and check if everything is working properly. You may need to adjust your temperature settings or rearrange your food items if needed.
Q: How do I clean my Whirlpool French door refrigerator freezer drawer?
A: To clean your Whirlpool French door refrigerator freezer drawer, you need to remove it first by following our easy guide above. Then, wash it with warm water and mild soap or detergent. Rinse well and dry with a soft cloth or towel. You can also use a non-abrasive cleaner or baking soda solution for stubborn stains or odors.
Q: How do I adjust my Whirlpool French door refrigerator freezer drawer?
A: Some models of Whirlpool French door refrigerator freezer drawers have adjustable dividers that can be moved to accommodate different sizes of items. To adjust your freezer drawer, you need to remove it first by following our easy guide above. Then, reposition the dividers at your desired location by inserting them into different slots or holes on the basket.
Q: How do I remove the ice maker from my Whirlpool French door refrigerator freezer drawer?
A: Some models of Whirlpool French door refrigerator freezer drawers have an ice maker that can be removed for cleaning or replacement. To remove the ice maker, you need to remove the freezer drawer first by following our easy guide above. Then, locate the ice maker on the left side of your drawer and unplug its wire harness connector. Next, remove the screws that secure the ice maker to the drawer and lift it out.
Removing and replacing your freezer drawer from your Whirlpool French door refrigerator is a simple task that can help you keep your freezer clean and organized. By following our easy guide, you can remove your drawer in minutes and enjoy more space and convenience in your freezer.
